SEW-Eurodrive MOVIPRO PHC11A-M1-2A-A1 Series - Page 26

3
Unit structure
Function modules
Operating Instructions – MOVIPRO
®
PHC11A-..M1-..2A-A1/..
26
3.7.2 PFH.. communication and control unit
The function module consists of the following internal elements.
Fieldbus interface
Depending on the design, the unit offers one of the following communication options:
Communication Function module
LAN, TCP / UDP PFH-E4..
WLAN, TCP / UDP PFH-W4..
LAN, TCP / UDP
The unit has an Ethernet interface for connecting to the fieldbus. The bus is physically
connected via a plug connection as described in the "Electrical connections" chapter.
WLAN, TCP / UDP
NOTICE
Damage to the radio modem due to missing terminating resistors.
Damage to the radio modem.
• Connect a 50 Ω terminating resistor to those antenna ports that are not in use.
The MOVIPRO
®
unit has a "Radio Ethernet Client 5 GHz" (REC5) radio modem for
connection to a wireless infrastructure network. It is suitable for the frequency blocks
of 2.4 GHz (IEEE 802.11b / g) and 5 GHz (IEEE 802.11a).
The radio connection is designed for communication with the higher-level controller.
The MOVIPRO
®
unit is accessible as a terminal in the network.
For more information, technical data and approvals, refer to the latest edition of the
addendum to the "MOVIPRO
®
Drive and Application Controller – REC5 Radio Mo-
dem" operating instructions.
Processor unit
The unit is equipped with a Micro DLC processing unit. It is programmed in the high-
level language C. The unit is designed for operation with the SEW-EURODRIVE
SEWOS operating system. This allows for quick configuration of customer-specific
plants. It is based on a system of central data management and diagnostics as well as
a decentralized controller. You need a data server with MOVIVISION
®
software in or-
der to operate a device with SEWOS.
For detailed information, refer to the "MOVIVISION
®
Operating and Display Software"
manual.
20278543/EN – 09/2014