SEW-Eurodrive MOVIPRO PHC11A-M1-2A-A1 Series - X4101: CAN Bus - System Bus

7
Electrical connections
X4101: CAN bus – system bus
Operating Instructions – MOVIPRO
®
PHC11A-..M1-..2A-A1/..
71
7.16 X4101: CAN bus – system bus
The following table shows information about this connection:
Function
Internal CAN bus (system bus) – output
Connection type
M12, 5-pole, female, A-coded
Wiring diagram
1
4
3
2
5
9007201519557259
Assignment
No. Name Function
1 CAN_SHLD Shield/equipotential bonding
2 +24V DC 24 V output
3 GND Reference potential
4 CAN_H CAN data line (high)
5 CAN_L CAN data line (low)
INFORMATION
If there is no node connected here, you must terminate the CAN bus with a 120 Ω
resistor.
7.16.1 Connection cables
The following table shows the cables available for this connection:
Cable Length /
Installation
type
Length: 5 m, part number: 13286331
Length: 10 m, part number: 13286358
Length: 15 m, part number: 13286366
Cable design: ((1X2X0.2)+(1X2X0.32)+1X0.32)
M12, male, A‑coded↔ M12, female, A‑coded
Fixed length
20278543/EN – 09/2014