SEW-Eurodrive MOVIPRO PHC11A-M1-2A-A1 Series

To Next Page

To Previous Page

Electrical installation

MOVITRANS® energy supply

Operating Instructions – MOVIPRO

PHC11A-..M1-..2A-A1/..

• Thermal properties (e.g. temperature stability, heating of the unit, flammability

class)

• EMC behavior (such as interference emission limit values, compliance with interfer-

ence immunity values stipulated in standards)

• Functional safety (approvals according to EN ISO 13849-1)

Non-SEW cables not explicitly recommended by SEW‑EURODRIVE must meet at

least the requirements of the following standards and have been permitted according

to these standards:

• IEC 60309

• IEC 61984

• IEC 60204

6.3 MOVITRANS

energy supply

MOVITRAN

S® energy

supply

Also observe the information in the following chapters:

• Low-voltage supply systems (→ 2 47)

• Contactors (→ 2 48)

• Cable routing (→ 2 48)

• Installation altitude higher than 1000 m above sea level (→ 2 48)

• Shielding (→ 2 49)

• Unit output (→ 2 49)

• Braking resistor (→ 2 50)

• Using prefabricated cables (→ 2 50)

6.3.1 Installation notes

Observe the following points for electrical installation:

• Observe the general safety notes.

• Comply with all instructions referring to the technical data and the permissible con-

ditions where the unit is operated.

6.3.2 Electromagnetic compatibility (EMC)

INFORMATION

MOVIPRO

units can cause EMC interference within the permitted limit range ac-

cording to EN 61800-3.

For detailed information on EMC-compliant installation, refer to the publication “Drive

Engineering – Electromagnetic Compatibility in Drive Engineering.”

20278543/EN – 09/2014

SEW-Eurodrive MOVIPRO PHC11A-M1-2A-A1 Series - MOVITRANS Energy Supply