SEW-Eurodrive MOVIPRO PHC11A-M1-2A-A1 Series - Main Axes; Control of the Brake Modules

8
Startup
Main axes
Operating Instructions – MOVIPRO
®
PHC11A-..M1-..2A-A1/..
87
8.4.3 Additional Information
For additional information, refer to the following documentation:
• "MOVIVISION
®
Parameter and Diagnostics Tool" manual
• "MOVIVISION
®
- MOVIPRO
®
Software Interface" manual
• "MOVIDRIVE
®
MDX60B/61B" system manual
8.5 Main axes
The unit is delivered with the following main axis addresses: Position m of the plug
connector designation is relevant for the SBus address of the respective axis.
The following table shows 2 examples:
Connection Axis m SBus address
X201c_1n 1 19 + 1 = 20
X201c_2n 2 19 + 2 = 21
… … …
X201c_mn m 19 + m
8.6 Control of the brake modules
The safety-related BST brake module is controlled via output DB00 of the frequency
inverter for single drives.
20278543/EN – 09/2014