5
Mechanical installation
Requirements
Operating Instructions – MOVIPRO
®
PHC11A-..M1-..2A-A1/..
30
5 Mechanical installation
5.1 Requirements
WARNING
Risk of crushing if the load falls.
Severe or fatal injuries.
• Do not sit or stand underneath the load.
• Secure the area in which the mechanical installation is to take place.
NOTICE
Risk of collision.
Damage to plant and unit components.
• Always position the unit in such a way that it will not collide with other compo-
nents or design elements along the travel route.
The following preconditions must be fulfilled for the mechanical installation:
• Trained specialists perform the installation.
• The information provided in the technical data and the permitted conditions for the
operating location of the unit are observed.
• The minimum clearance and distance and the required gaps for using a mounting
plate are complied with; see the "Minimum clearance" section.
• The unit is only mounted using the intended mounting options.
• The selection and dimensioning of the mounting and locking elements are in line
with the applicable standards, the technical data of the units and the local require-
ments.
• The bore dimensions are calculated in line with the respective type of fastening.
See the following sections.
• The mounting and locking elements fit into the existing bores, threads and counter-
sinks.
• All display and actuator elements are visible and accessible after installation.
20278543/EN – 09/2014
To Next Page
Loading...
