SEW-Eurodrive MOVIPRO PHC11A-M1-2A-A1 Series - Page 95

10
Service
Line connection energy supply
Operating Instructions – MOVIPRO
®
PHC11A-..M1-..2A-A1/..
95
Reset
WARNING
Danger due to unintended motor startup.
Severe or fatal injuries.
• Comply with the startup instructions.
• Set the controller inhibit.
• Switch off the output stage.
• Decouple the drive.
• Deactivate the auto-reset function for drives that start up automatically.
An error message can be acknowledged by:
• Switching the voltage supply off and then on
Always maintain a minimum switch-off time of 1 minute.
• Reset using the parameters of the frequency inverter
• Reset via the process data interface
Auto reset performs up to 5 unit resets with an adjustable restart time.
10.1.5 Shutdown
To shut down the unit, disconnect it using appropriate measures.
WARNING
Electric shock due to charged capacitors.
Severe or fatal injuries.
• Observe a minimum switch-off time after disconnecting the supply system:
10 minutes.
10.1.6 Storage
Observe the following instructions when shutting down or storing the safety controller:
• If you shut down and store the unit for a longer period, you must cover the connec-
tions with the protective caps supplied.
• Place the unit on a side without connectors during storage.
• Make sure that the unit is not subject to mechanical impact during storage.
• Connect the unit to the power supply for at least 5 minutes every 2 years.
Observe the notes on storage temperature in chapter "Technical data".
20278543/EN – 09/2014