On-Screen Display Menu
5 Press ENTER to start checking the data
in
the
USB memory device.
6 During the data checking, "Checking" blinks.
• The current version of the TV software and the version
of the update
file
on the USB memory device are
displayed. To update the TV software with the update
file. select "Yes", and then press
ENTER.
Example
..
-
•
If
the USB memory device
is
not properly installed or
the correct update file cannot be found on the USB
memory device,
an
error message
is
displayed.
Check the
file
on the USB memory device, and then
reinsert the USB memory device correctly.
7 Press ENTER to start updating.
• The screen becomes dark for a while until the update
screen can be displayed. Please wait for the update
screen to appear. Do not unplug the
AC
cord.
•
Example
m!iD
• Do not remove the USB memory device or unplug the
AC cord while the software
is
being updated.
8 When the software
is
successfully updated, a
screen
is
displayed indicating that the update
process
is
completed.
After this screen
is
displayed, the
TV
automatically
turns off and then turns
on
again.
Example
•
If
the update has failed, check the file
in
the USB
memory device and try Software Update again.
Failed to complete update
Retry Software Update
If
system
Update
falls
agaIn,
contact the customer service center
9 After the screen shown below
is
displayed, press
ENTER.
System
software
was
successfully updated
Remove
the
USB
memory
device
--
10
Remove the USB memory device.
@-
31
To Next Page
Loading...
