Supplied Accessories
Make sure the following accessories are provided with the product.
Remote control unit
(x
1)
Page 7
"AAA" size battery
(x2)
Page 8
AC cord
(x
1)
Page 7
Cable clamp
(x
1)
Page 7
Stand unit
(x
1)
Page 6
Operation manual
(x
1)
1m
• Always use the
AC
cord
supplied with the 1V.
•
To
avoid scratching the frame
or
screen, please use a soft, lint free cloth for cleaning. Approved cleaning cloths are available
directly from Sharp
in
single
(OOZ
-LCD-CLOTH)
or
triple
(OOZ
-LCD-CLOTH-3) packs. Call 1-800-BE-SHARP for ordering,
or
VISIT www.sharpusa.com/SharpDirect.
QUICK
REFERENCE
Attaching the Stand
• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work spread cushioning over the base area
to
lay the
1V
on. This will prevent it from being damaged.
mm
• Attach
the
stand
in
the correct direction.
• Do not remove the stand from the TV unless using an optional wall mount bracket
to
mount it.
• Be sure to follow
the
instructions. Incorrect installation of the stand may result
in
the TV falling over.
1 Confirm that there are 8 screws
(4
short screws
and 4 long screws) and a hex key supplied with the
stand unit.
2 Attach the supporting post for the stand unit onto
the base using the box for the stand unit as shown
below.
•
The
supporting post attaches
to
the
base
at
an
off-centered
location
on
the
base.
Be
sure
to attach
the
supporting post
in
the
direction indicated below
and
attach
the
stand
to
the
TV
with
the
wider
side
of
the
base
facing
forward.
, , "
__
Long screws
---.j.
-"':
-
A
@)-
6
3
CD
Insert the stand into the openings on the bottom
of the
TV.
eg)
Insert and tighten the 4 short screws into the 4
holes on the rear of the
TV.
Hex key
Sllort screws
1m
• To detach the stand, perform the steps
in
reverse order.
To Next Page
Loading...
