54
GB
SHOWVIEW
®
programming system
SHOWVIEW system is a timer
programming system which
simplifies timer recording
programming. Instead of entering
the date, channel and recording
time, you simply enter a
ShowView
programming number
that you can find in your TV
listings.
NOTE:
There are two ways to enter a
GUIDE CH NO. :
•To select numbers you can either
use the numeric keys and then
ENTER, or you can press
ENTER first then use the
/
buttons to select a number,
followed by ENTER.
• When using the numeric keys,
enter using two digits for TUNER
CH NO.
Preparation:
•Turn ON the TV and select it’s AV channel (this may be labelled
EXT / AUX etc.)
• Load a recordable DVD or video tape into the unit.
• Press DVD/VCR to select the appropriate mode.
Checking the channel setup to use the SHOWVIEW
system
Before you can use the SHOWVIEW system you need to set up the
channel mapping. This ensures that the SHOWVIEW system uses the
correct channels for recording by matching up the preset channels in
the recorder with “guide channels”. You can find these guide channel
numbers in your local TV guide or newspaper TV listings.
1
Press SETUP and press
or to select “CHANNEL SETUP”
and press ENTER.
The Channel Setup menu will appear.
2
Press
or to select “GUIDE CH SET” and press ENTER.
A window appears to set a guide channel number and the
corresponding tuner channel number.
3
Enter a GUIDE CH NO. (guide channel number).
TV/VIDEO
To Next Page
Loading...