104
FAX FUNCTIONS
6
To finish the storing procedure, press the [BLACK & WHITE START] key. If you wish
to program an option such as chain dialing, transmission speed, or international
transmission mode, press the [OK] key.
• If you pressed the [BLACK & WHITE START] key, you will return to step 3. If you wish to store another or
Speed Dial number, repeat steps 3 to 6. If you have finished storing auto-dial numbers, press the [BACK]
key.
• If you pressed the [OK] key, go to the appropriate page for the option that you wish to program.
• To select "CHAIN DIAL", go to "Chain Dialing" (p.104).
• To set the "TRANSMISSION SPEED", go to "Transmission speed setting" (p.104).
• To set the "INTERNATIONAL TRANSMISSION MODE", go to "International transmission mode setting"
(p.105).
● Chain Dialing
To set an auto-dial number as a Chain Dial number, complete "Editing and deleting auto-dial numbers" (p.106).
1
Select "Chain Dial" with the [ ] or [ ] key and press the [OK] key.
• If checkmark appears to the left of "Chain Dial", it is already selected.
• To exit, press the [BLACK & WHITE START] key.
2
Select "On" or "Off" with the [ ] or [ ] key.
● Transmission speed setting
To set the transmission speed, complete "Editing and deleting auto-dial numbers" (p.106).
1
Select "TX Speed" with the [ ] or [ ] key and press the [OK] key.
2
Select the desired transmission speed with the [ ] or [ ] key.
About the setting options
When storing and editing and Speed Dial numbers, you can also select the setting options below. Chain dialing
cannot be combined with any of the other setting options.
When you select a setting option, a checkmark appears in the setting option screen.
• Chain Dialing You can enable or disable Chain Dialing for a Rapid key or Speed Dial
number. (p.104)
• Transmission speed You can set the transmission speed to 33,600 bps (maximum speed),
14,400 bps (high speed), 9600 bps (middle speed), or 4800 bps (low
speed). The initial setting is 33,600 bps (maximum speed). (p.104)
• International transmission mode The international transmission mode can be set to "Off" or one of
modes 1 to 3. The initial setting is "Off". (p.105)
When a number is set as a Chain Dial number, the destination fax number can be up to 48 digits long.
Set the transmission speed only when you know what speed is most suitable, such as when you are sending a
fax to a foreign country and telephone line conditions are bad. If you do not know the line conditions, do not
change this setting.
If you select a speed other than 33,600 bps (maximum speed), a checkmark will appear next to "TX Speed"
when you return to the option setting screen. This setting is not effective for polling transmission.
To remove the checkmark and return the transmission speed setting to "33,600 bps (maximum speed)", press
the [LOGOUT]
key ( ).
Note
Note
Note
Note
To Next Page
Loading...
Need help?
General
