15
BEFORE USING THE MACHINE
POWER ON AND OFF
The power switch is located on the left side of the machine.
POWER ON
Turn the power switch to the "ON"
position.
While the machine is warming
up, the message "Warming
Up" will appear in the
message display.
POWER OFF
Make sure that the machine is not in
operation and then turn the power switch
to the "OFF" position.
If the power switch is turned off while the machine is in
operation, a misfeed may occur and the job that was in
progress will be canceled.
POWER SAVE MODES
The machine has two power save modes to reduce overall power consumption thereby reducing the cost of
operation. In addition, these modes conserve natural resources and help reduce environmental pollution. The two
power save modes are "Preheat mode" and "Auto power shut-off mode".
Preheat mode
This function automatically switches the machine to a low power consumption state if the duration of time set in the
system settings elapses without the machine being used when the power is on. In preheat mode the display turns
off. Normal operation automatically resumes when a key on the operation panel is pressed, an original is placed, or
a print job or fax is received.
Auto power shut-off mode
This function automatically switches the machine to a state that consumes even less power than preheat mode if the
duration of time set in the system settings elapses without the machine being used when the power is on. During auto
power shut-off, only the [ENERGY SAVE] indicator blinks. To restore the machine to normal operation, press the
[ENERGY SAVE] key. Normal operation also resumes automatically when a print job or fax is received or scanning is
begun from a computer. While auto power shut-off is in effect, pressing a key other than the [ENERGY SAVE] key will
have no effect.
DEFAULT SETTINGS
The machine is set at the factory to return all settings to the default
settings one minute after a copy job is finished (auto clear function) or
when the [CA] key is pressed. When the settings return to the default
settings, any functions that were selected are canceled.
The auto clear time can be changed in the system settings.
(p.179)
In the default state the display shown below appears. The default state of
the display may vary depending on settings in the system settings.
• The machine reverts to the initial settings when it is first turned on, when the [CA] key is pressed, or when no
keys are pressed for the preset "Auto clear" time following the end of a copy job. When the machine reverts to
the initial settings, all settings and functions selected to that point are canceled. The "Auto clear" time can be
changed in the system settings. (p.179)
• The machine is initially set to automatically enter power save mode if not used for copying or printing, for a
preset period of time. This setting can be changed in the system settings. (p.180)
• Before using fax mode, read the following sections and then turn on the power.
"TO USE THIS PRODUCT CORRECTLY AS A FACSIMILE" (p.79)
"POINTS TO CHECK AND PROGRAM AFTER INSTALLATION" (p.80)
Note
The preheat activation time and the "Auto power shut-off timer" can be changed using system settings.
Note
To Next Page
Loading...
Need help?
General
