122
FAX FUNCTIONS
WHEN AN ALARM SOUNDS AND A
WARNING MESSAGE IS DISPLAYED
When an error occurs during a transaction, an alarm will sound and a message will appear in the display.
If one of the following messages appears, follow the instructions in the table.
If another messages appears, see "INDICATORS AND DISPLAY MESSAGES" (p.151).
SELF-DIAGNOSTIC FUNCTION
The machine has a self-diagnostic function that automatically stops operation if a problem occurs in the machine. If
a problem occurs in fax mode, the following display appears.
MESSAGES DURING NORMAL OPERATION
Message
(alarm sounds)
Meaning of message Solution Page
XXXXXX
Line error.
An error prevented completion of the
transaction.
Try the transaction again. –
Message display Action
Call for service.
code:xx xx.
Turn off the power and then turn it back on. If the error is not cleared, note the 2-digit main code
and the 2-digit sub-code and then contact your dealer.
Message Meaning of message
SENT xx%
No.001 P-xxx
This appears when a direct transmission ends ("xx" indicates the number of pages).
READING xx%
No.001 P-xxx
The original is being scanned into memory (during memory transmission).
Stand-by. 100%
22 AUG FRI 10:25
The machine is in the standby state.
ENTER DIAL # This appears when the [SPEAKER] key has been pressed.
Main code Sub code
To Next Page
Loading...
Need help?
General
