203
WEB FUNCTIONS IN THE MACHINE
CONFIGURING SMTP, DNS AND
LDAP SERVER SETTINGS
The procedures for using [Quick Setup] are explained here. [Quick Setup] is used to quickly configure only the
required settings for "SMTP", "DNS", and "LDAP" servers. These settings are normally configured first.
SMTP server: SMTP is used to transmit e-mail that is sent using Scan to E-mail.
To use these transmission methods, your SMTP server settings must be configured.
DNS server: If you entered a host name in "Primary SMTP Server" or "Secondary SMTP Server" of "SMTP",
you must also configure your DNS server settings.
You will also need to configure your DNS server settings if host names will be entered in
"Hostname or IP Address" when storing destinations for Scan to Desktop.
LDAP server: If mail addresses are managed on your network by an LDAP server, the e-mail addresses stored
in the LDAP server can be used for Scan to E-mail.
To allow the machine to use the e-mail addresses in the LDAP server, the LDAP server settings
must be configured in the Web page.
5
Click [Quick Setup] in the menu frame.
6
Enter the required information in "SMTP", "DNS" and "LDAP".
7
When you have completed all of the entries, click [Submit].
The entries will be stored.
If you need to configure advanced settings for the SMTP, DNS, and LDAP servers, follow the procedures below.
• Configuring SMTP and DNS server settings
Click [Services] in the menu frame to display the services setup screen. Select the desired server and then
configure the required parameters for that server.
• Configuring LDAP server settings
Click [LDAP] in the menu frame to display the LDAP setup screen. Configure the required parameters.
Note
To Next Page
Loading...
Need help?
General
