181
SYSTEM SETTINGS
Enter Auto Power Shut-Off after the
Remote Job
This function works in Auto Power Shut-Off mode.
When the machine completes a print job received from
the PC or outputs received fax data, the machine
immediately returns to the Auto Power Shut-Off mode.
Toner Save Mode (Copy)
Toner Save Mode (Print)
You can reduce the amount of toner used for
copying/printing.
List Print
This is used to print lists and reports that are only for
use by the administrator of the machine.
Select the [List Print] to configure the settings.
AutoColorCalib.
This is used to perform automatic color correction
when the color in color copies is off. The machine
prints a test patch, the test patch is scanned, and the
color is automatically corrected.
After the [OK] is selected and a test patch is printed, a
message appears prompting you to begin automatic
calibration. Place the test patch on the document glass
as shown below (so that the light patch at the edge of
the page is to the left).
Align the upper left corner of the original with the mark.
Lay copy paper (about five sheets) that is the same
size as the test patch on top of the placed test patch,
gently close the automatic document feeder, and
select the [OK].
Toner Save Mode (Print) is only effective
when the machine's printer driver is not
used. When the printer driver is used, the
printer driver setting takes precedence.
This function may not operate in some
applications and operating systems.
Fax Settings
Shows the current state of the
system settings, as well as the
sender name, sender number,
polling passcode numbers, and
forwarding numbers.
Inbound
Routing
Shows the inbound routing settings
for routing received faxes on your
network.
User Usage List
Shows the communication time and
number of pages transmitted by each
user.
Activity Report
Shows a log of past communication
performed on the machine (date of
communication, name of other party,
time required, result, etc.).
Junk Fax # List
Shows the stored fax numbers from
which reception in "Anti Junk Fax"
(p.188) is blocked.
User Info. Print
The user name, user number, paper
used, paper limits, and function
permission settings can be printed
for each user.
*Cannot be printed if no users are
registered.
Note
• Before executing Auto Color Calibration,
check to see if the registration adjustment
is correct. If the registration adjustment is
not correct, perform "Registration
Adjustment" (p.179).
• If the color is still off after performing Auto
Color Calibration, repeating Auto Color
Calibration once again may improve the
color.
Align the upper left corner of the original
with the mark.
Note
To Next Page
Loading...
Need help?
General
