189
SYSTEM SETTINGS
Polling Passcode # Mode
When "Polling Security" is enabled, use this setting to
program (or delete) the fax numbers of the machines
that are allowed to poll your machine. Programmed fax
numbers are called passcodes. Up to 10 fax numbers
can be programmed. To check the programmed
numbers, print the "List Print" (p.181).
If you make a mistake, move the cursor to the mistake
with the [ ] or [ ] keys and enter the correct number.
Scanner
System settings for the scanner function are explained
below.
Select the [Scanner] to configure the settings.
Disable USB Scan
Select whether or not scanning from a computer and
scanning from the machine are disabled when a USB
connection is used.
Default setting is "No" (disabled).
New Default
This is used to change the default settings for the
original size, resolution, format, and scanning
exposure in B/W mode. (For details, see "STORING
SCANNING SETTINGS" (p.130).)
• For details on each setting, see the pages below.
"Original Size Enter" (p.130)
"Resolution" (p.130)
"Format" (p.131)
"Mono2/Grayscale" (p.131)
To clear a passcode number, follow these
steps:
(1) Select "Delete" and then press the [OK]
key.
(2) Enter the control number that identifies
the number you wish to clear, and then
press the [OK] key.
(3) Select "Delete" with the [ ] or [ ] key
and then press the [OK] key.
Note
To Next Page
Loading...
Need help?
General
