98
FAX FUNCTIONS
AUTOMATIC TRANSMISSION AT A SPECIFIED TIME
This feature enables you to set up a transmission or polling operation to be performed automatically at a specified
time up to a week in advance. This is convenient when you will be out of the office or for transmission at off-peak
nighttime rates. A combined total of 50 timer transmission and memory transmission jobs can be stored.
1
Select "Timer Mode" and press the [OK] key.
If a time has been specified, a checkmark appears in front of "Timer Mode". To cancel a specified time, press
the [LOGOUT] key
() in the above display with "Timer Mode" highlighted.
The current time appears in the screen. If the current time is not correct, press the [CA] key to cancel the
operation and see "Daylight Saving Time" (p.176) to correct the time setting.
2
Select the day of the week with the [ ] or [ ] key.
The selected day is highlighted. If you select "No Select Days", the transmission will be performed
as soon as the specified time arrives. To return to the "Time Setting" display, press the [BACK] key.
• After a timer transmission is performed, the information (image, destination, etc.) is automatically cleared from
memory.
• To perform a timer transmission, the original must be scanned into memory. It is not possible to leave the
original in the document feeder or on the document glass and have it scanned at the specified time of
transmission.
• The date and time is set in the machine using the system settings.
(See "Daylight Saving Time" (p.176).)
• Only one polling timer operation can be set up at a time. If you wish to set up multiple timer polling operations,
combine the machines to be polled into one serial polling operation with a timer setting (see "Serial polling
mode" (p.101)).
Note
• To cancel a timer operation after the above procedure has been completed, follow the procedure in
"CANCELING A FAX TRANSMISSION" (p.93).
• A timer job number is automatically assigned to the operation. This number can be used to cancel a stored job.
(See the note Canceling a stored transmission job screen (screen of step 3)" on p.94.)
• Other operations can be performed after a timer operation is set up. If another operation is in progress when
the specified time arrives, the timer transmission will begin when the job in progress is completed.
Note
To Next Page
Loading...
Need help?
General
