CHECKING THE IMAGE BEFORE PRINTING
This function requires the hard disk drive.
When "Received Data Image Check Setting" is enabled* in the system settings (administrator), you can check a
received image in the touch panel before printing it out. When this function is enabled, follow the steps below to print a
received image.
* The factory default setting is disabled.
Depending on the size of the received data, part of the image in the image check screen on the touch panel may not appear.
1
When an image is received, a confirmation
prompt will appear. Touch the [Yes] key.
If this message appears while you are configuring settings of
any type and you touch the [Yes] key, the settings that you are
configuring will be canceled. If this message appears in another
mode, you will return to the base screen of image send mode
after checking the image.
2
Select the received image
(1) Touch the key of the received image that
you want to check.
Multiple received images can be checked.
(2) Touch the [Image Check] key.
• To show thumbnails of the received images, touch the
[Thumbnail] key.
• To delete an image that has been selected, touch the
[Delete] key. To print an image that has been selected,
touch the [Print] key.
3
Check the received image and then
touch the [Print] key.
Printing begins.
For information on the image check screen, see "IMAGE
CHECK SCREEN" (page 5-118).
If the screen of step 1 appears when you are configuring settings in the setting screens of any of the modes, the configured
settings will be canceled if you view the image. After viewing the image, you will return to the base screen of image send
mode, regardless of which mode you were in previously.
System Settings (Administrator): Received Data Image Check Setting
Use this to specify whether or not a received Internet fax can be viewed before it is printed.
To Next Page
Loading...
Need help?
General
