The chart below shows the procedure to follow in the event a problem occurs. Use it as a troubleshooting guide.
TROUBLESHOOTING PROBLEMS
Check this chapter first
You may find a solution to your problem here.
Ask the administrator for help
Inform the machine's administrator of the nature of the problem and ask for
help.
Refer to other instruction manuals
You can sometimes find the solution to your problem in other chapters in this
manual or in the other instruction manuals included with the machine.
Turn the power off and then on again
Turning the power off and on may solve the problem in some cases, so try
doing so before attributing the problem to a malfunction.
Press the [POWER] key ( ) to turn off the power and switch the main power switch to the "off" position. Wait at least 10
seconds and then switch the main power switch and the [POWER] key ( ) back on in that order.
• When turning off the main power switch, ensure that each of the lamps on the operation panel has been turned off.
Contact your dealer or nearest SHARP Service
Department.
If, having tried the above steps, your problem remains unsolved, contact the
dealer from whom you purchased the machine or your nearest SHARP
Service Department.
To Next Page
Loading...
Need help?
General
