● In case of leakage of argon gas
If it is left, lack of oxygen may occur. Immediately ventilate the
working area and check for gas piping.
● In case of abnormal temperature raise of the spectrometer unit
The room temperature should be kept within the range of 10 - 28°C.
If it exceeds 30°C, the temperature of the spectrometer unit may
raise abnormally.
If the temperature of the spectrometer unit exceeds 42°C, the buzzer
at the temperature alarm will give a warning sound. In that case,
turn OFF the AIRCON switch on the switch panel and make sure the
room temperature is within the range of 10 - 28°C. Then, wait until
the temperature inside the spectrometer goes down to the room
temperature, and turn ON the AIRCON switch again.
If the buzzer gives a warning sound even after that, turn OFF the
AIRCON switch and contact your Shimadzu representative.
● Safety measure for other emergency occurrences
If an unpredictable happening like an earthquake, fire, etc. occurs,
first press the emergency stop switch, and then turn OFF all the
power of the distribution panel. After this, each staff must carefully
take an appropriate action to maintain his/her safety.
During a power outage
In case of a power failure, follow the procedure described below.
1. Turn off the MAIN breaker on the switch panel.
2. Turn off the AIRCON, CONSOLE, and SOURCE switches on the switch panel.
3. Turn off the power switch of the vacuum pump.
4. When the power is back, turn on the MAIN breaker on the switch panel.
5. Turn on the AIRCON, CONSOLE, and SOURCE switches on the switch panel.
6. Turn on the power of the vacuum pump.
To Next Page
Loading...
