Shimadzu PDA-7000 - Peripheral Equipment; Other Environmental Requirement; Moving and Disposing of the Product

6 Installation
6-4
• If the sample is lead, tin or zinc-based, connect the gas outlet on the back of spark
stand case to exhaust system, and exhaust the air inside spark stand case to
outdoors.
6.8 Peripheral equipment
• Table
• Shelf
• Desiccator
• Thermometer and Hygrometer
• Belt sander / Lathe
• Sample pretreatment system
(Ex.) Belt sander FS-3N P/N 085-50206-11 50Hz type
Belt sander FS-3N P/N 085-50206-12 60Hz type
Bench lathe L-1000 P/N 085-50102-01
• Electrode grinder
(Ex.) Electrode grinder MT-11M P/N 085-50802-01 AC100V type
Grinding wheel CBN75#100 P/N 085-50802-51
• Electrode grinder (for control gap electrode ø2mm)
(Ex.) Electrode grinder MT-10M P/N 085-50801-01 AC100V type
Grinding wheel CBN60#170 P/N 085-50801-11
6.9 Other environmental requirement
• The installation site should be free of corrosive or explosive elements.
• Avoid use near equipment that generates powerful magnetic fields such as an
electric furnace.
If the installation site is near such equipment, contact your Shimadzu service
representative.
6.10 Moving and Disposing of the product
Contact your Shimadzu service representative before moving or disposing
PDA-7000.