Shini Group
Technology & Marketing Dept
Issued by department: Date: Language: Document Name: Revision: Page:
Shini/CSC-TM
2013-11 zh-cn Shini product repair manual.doc
1.0 60 (62)
Catalog:
template:Standard_CN.dot; filename: Shini product repair manual; Printdate: 8/1/2014 1:58:00 PM; savedate: 8/1/2014 1:58:00 PM
4) Mount the bearing on the motor straightly (note: When installing bearing four foot
hole aligned with the motor 4 screw holes, installation direction must be
consistent with the direction of the figure below), use rubber hammer to knock
bearing four feet above properly to make sure bearing in place; remove the seal
central section (Check for damage and other problem) and use tina water
moistened cloth clean the seal surface; then mount the seal central section on the
motor, as shown in the figure below.
Pic 20-4
5) Use a brush to apply clean lubricant to seal edge, mount pump shaft seal ring,
and check for damage and other problem, as shown in the figure below.
Pic 20-5
To Next Page
Loading...
