130
NICE
1. Place the new RC (to be encoded) and the old RC (already
working in receiver) facing each other.
2. Press and hold the new RC (to be encoded) button until the
red LED of the old RC (already working in receiver) lights up.
At this point release the button.
3. Press the button of the old RC (already working in receiver)
while it is flashing. LED of the new RC will light up to
confirm the correct duplication.
If the above process should not be successful, get closer to the
receiver and proceed with the following instructions:
1. Press for about 7 seconds the button you want to encode on
the new RC.
2. Press the operating RC button 3 times in succession.
3. Press the new RC button again.
Wait at least 10 seconds and try to open the gate with the fresh
programmed RC. To duplicate further RCs repeat the process
starting from point 1.
ON2E FM
Cod. 6901036
ON4E FM
Cod. 6901037
Compatible with ONE FM RCs
868.35 MHz
Rolling code FM
DUPLICABLE THROUGH UNIVERSAL RCs
EVO
To Next Page
Loading...