103
FADINI
The duplication process should be carried out in the
immediate proximity of the receiver.
1. Press and hold the first button of the new RC (to be coded)
until LED goes out then release the button.
2. Press and hold the second button of the new RC (to be
encoded) until LED goes out, then release the button.
3. Press and hold the first button of the operating RC in
receiver until LED goes out, then release the button.
4. Press and hold the second button of the operating RC in
receiver until LED goes out, then release the button.
5. Wait a few seconds and try the new RC.
IMPORTANT NOTE:
RC Fadini SITI or BIRIO are often pre-coded with a “system code”
by the installer. In this case the process described above does
not work.
To duplicate these RCs, you will need to contact the installer of
the automation exclusively.
BIRIO 2 868
Cod. 6900995
BIRIO 4 868
Cod. 6901005
868.35 MHz
Rolling code
To Next Page
Loading...