Siemens LME71 Series

75/116
Smart Infrastructure Basic Documentation LME7... CC1P7105en
13 Operation via AZL2 24.07.2020
13.7 Service level
The service level is used to display information about errors including the error history.

Note!
When on the service level, you can press or to display the next or the previous
parameter.
Instead of pressing , you can also press
/
reset
for <1 second.

Note!
Press
ESC
or
/
reset
for >8 seconds to return to the normal display.

Parameter
Parameter value
Figure 22: Service level
Note!
No change of values on the service level.
If characters are displayed by the parameter,
the value may consist of more than 5 digits.
Press
/
reset
for >1 s and <3 s to display the value.
Press
/
reset
for >3 s or
ESC
to return to the
selection of the parameter number (flashing).
13.7.1 Display of the service level
/
reset
P
Vh
mi n
s%
Bild 21/0707
Press
/
reset
for >3 s until SEr appears.
When releasing
/
reset
, you are on the service level.
No.
Parameter
Service level
920 Current PWM signal fan
936 Normalized speed
951
Mains voltage
954 Flame intensity