AT command interface
Version 8 dated 15.03.00 133
Siemens Information and Communication Products
A
AT^MONI Monitor idle mode and dedicated mode
Test command
AT^MONI[=<peri-
od>]
Response
See execute command
Command is broken by any character sent to serial port
Parameter
<period>Display period in seconds
Execute command
AT^MONI
Response
Serving cell I Dedicated channel
chann rs dBm PLMN LAI cell NCC BCC PWR RXlev C1 I chann TS timAdv PWR dBm Q
89 49 -61 023203 3A98 4EAF 0 4 5 -102 41 I 116 7 1 10 -60 2
OK
Parameters
Serving cell:
chann Channel number
rs RSSI value (0–63)
dBm Receiving level in dBm
PLMN PLMN ID code
LAI Location area ID
cell Cell ID
NCC PLMN colour code
BCC BS colour code
PWR Maximal power level used on RACH channel
Rxlev Minimal receiving level (in dBm) to allow registration
C1 C1 coefficient for base station selection
Dedicated channel:
chann Channel number
TS Time slot
timAdv Timing advice in bits
PWR Current power level
dBm Receiving level in dBm
Q Receiving quality (0–7)
ChMod Channel coding:
SIGN signalling only
S FR speech full rate
S EFR speech enhanced full rate
D F96 data 9600 Bd
D F48 data 4800 Bd
D F24 data 2400 Bd
Reference Note
To Next Page
Loading...
Need help?
General