Application notes
Version 8 dated 15.03.00 169
Siemens Information and Communication Products
A
8.2.8 Phone call
1
8.2.8.1 Mobile originated call
8.2.8.2 Redial a number
8.2.8.3 Incoming call
8.2.8.4 Call a number stored in a phonebook
8.2.9 Data transfer
1. If not specifically mentioned, finish your commands with ENTER.
atd015265241; Dial the number you want to be connected with (always with dialling code)
_ You see the cursor while the called party’s phone is ringing
CONNECT Your call is answered
NO CARRIER Your partner has hung up
ath To end the connection before your partner
If your call is not answered:
_ the cursor disappears after some time
NO CARRIER
ATDL; The phone number last called is dialled again
CONNECT
....
RING Somebody calls you
ata ”Pick up the receiver”
atd>3; Rings up number 3 of your current phonebook
CONNECT
....
atd>”SM”,3; If you want to use a phonebook, different from the current one
CONNECT
....
atd015265241 Dial the number you want to be connected with (always with dialling co-
de)
NOTE
: do not use a semicolon at the end of the command
_ You see the cursor while the other’s phone is ringing
connect 9600 Your call is answered, the transfer rate is 9600 bit/s
..... You exchange data
+++〈pause〉 Switches from transparent to command mode
Though the phone connection is still active, characters are no longer trans-
ferred to the other modem
ato Returns to transparent mode
To Next Page
Loading...
Need help?
General