AT command interface
Version 8 dated 15.03.00 69
Siemens Information and Communication Products
A
AT+COLP Connected line identification presentation
Test command
AT+COLP=?
Response
+COLP: (list of supported <n>s) OK
Parameter
see set command
Read command
AT+COLP?
Response
+COLP: <n>,<m> OK
Parameter
see set command
Set command
AT+COLP=[<n>]
TA enables or disables the presentation of the COL (connected line) at the TE at a mobile origina-
ting call. It has no effect on the execution of the supplementary service COLR in the network.
Intermediate result code is returned from TA to TE before any +CR or V.25ter [5] responses. It is
manufacturer-specific if this response is used when normal voice call is set up.
OK
Parameter
<n> (parameter sets/shows the result code presentation status in the TA):
0
disable
1 enable
<m> (parameter shows the subscriber COLP service status in the network):
0 COLP not provisioned
1 COLP provisioned
2 unknown (e.g. no network, etc.)
Intermediate result code
When enabled (and called subscriber allows), an intermediate result code is returned before any
+CR or V.25ter responses:
+COLP:<num
ber>,<type>[
,<subaddr>
,<satype> [
,<alpha>
]]
Parameter
<number> string type phone number of format specified by <type>
<type> type of address octet in integer format; 145 when dialling string includes
international access code character "+", otherwise 129
<subaddr> string type subaddress of format specified by <satype>
<satype> type of subaddress octet in integer format (refer GSM 04.08 [8]
subclause 10.5.4.8)
<alpha> optional string type alphanumeric representation of <number>
corresponding to the entry found in phonebook
Reference
GSM 07.07
Note
Feature not available at some networks.
To Next Page
Loading...
Need help?
General