Siemens NXAIR - Page 191

Closing the connection compartment / connection duct
110-0084.9 / 15 NXAIR / ≤ 40 kA 191
Install the wiring duct cover.
Fix the wiring duct cover by screwing the bolts hand-tight:
• 2 bolts M8x20 with contact washers
Tighten the bolts with a tightening torque of 25 Nm.
Fig. 281: 2 bolted joints on wiring duct cover
Install the labyrinth.
Fig. 282: Labyrinth installed, front
Fig. 283: Labyrinth installed, top side