Unloading and erection
46 NXAIR / ≤ 40 kA 110-0084.9 / 15
6.13 Installing the transport units
Positioning the panels
Determine, according to the room planning, whether to start from the right or from the
left. Accordingly, the outermost left-hand or the outermost right-hand panel with end
wall will be the first in this order.
Lift the transport unit with suitable lifting gear or roller crowbar at the permissible points.
Place the first (i.e. rearmost) transport unit as exactly as possible on its place of
installation and place the second one at a distance of approx. 300 mm, so that the units
can still be aligned before bolting together.
Remove packing and transport materials from the place of installation. Remove any
dirt occurred during transport, as extreme cleanliness is required during installation.
The transport units are now in the correct order for assembling the switchgear.
6.14 Foundation cutouts
Dimensions of foundation cutouts
The dimension drawing containing all relevant dimensions of the foundation cutouts
for different panel versions is not part of these instructions. For further information,
see information drawings NXAIR, order number 110-2300.9.
6.15 Transport protection at the service truck
In order to prevent transport damages, the service truck is equipped at the factory with a plate for transport
protection. This transport protection must be removed before the first use of the service truck, and may be
disposed of.
Fig. 45: Service truck with transport protection
Lift the left and right unlocking levers (1) at the service truck, and hold them.
Remove and dispose of the transport protection (2).
The service truck is ready for use.
To Next Page
Loading...
