Unloading and erection
110-0084.9 / 15 NXAIR / ≤ 40 kA 33
6.8 Applying the lifting tool at the panel
Overloading
While moving panels, there is risk of overloading the human body.
Use only suitable lifting tools.
At the place of installation, observe the valid limit values for lifting and
carrying.
Put on personal protective equipment.
Damage to the switchgear panels
Direct application of lifting tools at the panel can cause damages.
Do not apply lifting tools such as roller crowbars at the sides or the rear of
the panel.
Do not apply lifting tools such as roller crowbars at the front of the panel if
the high-voltage door is closed.
Correct application of lifting tool
Applying the lifting tool at the sides of the switchgear frame is permissible if the high-voltage door is open.
Leave an appropriate distance to the inner edge of the door (arrow) on the side with
the high-voltage door when doing so.
Fig. 25: Permissible application on the Fig. 26: Permissible application on the
right below the switchgear frame left below the switchgear frame
To Next Page
Loading...
