EasyManua.ls Logo

Siemens NXAIR - Installing the Bushing Plate, the Vertical Partition and the Voltage Transformer Compartment in the Switching-Device Compartment

Siemens NXAIR
222 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Closing the connection compartment / connection duct
186 NXAIR / 40 kA 110-0084.9 / 15
11.4 Installing the bushing plate, the vertical partition and the voltage transformer compartment in
the switching-device compartment
CAUTION
Sharp-edged sheets
The metal parts of the voltage transformer compartment may have sharp edges.
Sharp-edged sheets inside the switchgear can cause injuries by getting cut and
damage cables.
Put on personal protective equipment (e.g. cut-resistant gloves and arm
sleeves).
When working inside the switchgear, it must be observed that cables do not
touch any sharp-edged sheets. Cover sharp-edged spots, if required.
CAUTION
High weight
The voltage transformer compartment is heavy.
The voltage transformer compartment must absolutely be lifted by
2 persons.
Put on personal protective equipment.
NOTICE
Damages inside the switching-device compartment
Damages inside the switching-device compartment / voltage transformer
compartment possible due to incorrect or incomplete installation of the partition /
bushing plate.
To fasten the partition / bushing plate, always screw all bolts up to the end
of the thread!
Preconditions
Feeder earthing switch in CLOSED position
High-voltage door open
Door to the voltage transformer compartment opened
In the switching-device compartment and in the voltage transformer compartment:
Low-voltage connector stowed away
Bushing plate and associated connecting elements available:
8 bolts M8x20 with contact washers and plain washers size 8
acc. to ISO 7093
3 bolts M8x20 with contact washers
Connecting cables and associated connecting elements available:
3 bolts M8 with contact washers and plain washers
Vertical partition and associated connecting elements available:
8 bolts M8x20 with contact washers and plain washers size 8
acc. to ISO 7093
Protection plate of switching-device compartment and associated connecting elements available:
4 nuts M8 with contact washers
Voltage transformer compartment and associated connecting elements available:
14 bolts M8x20 with contact washers

Table of Contents

Other manuals for Siemens NXAIR

Related product manuals