Integration in networks
You can integrate PC stations for PCS 7 in a network. Note the following:
Note
Install the PC stations locally or in a workgroup. Using this procedure prevents group policies
or domain restrictions from hindering the installation.
Do not use the following PC stations in PCS 7 for domain management (as DHCP or DNS
server, for example):
● OS server
● BATCH server
● Route Control server
If a server (OS server, BATCH server, Route Control server) is also used as a server for these
services, then the PCS 7 functions may be impaired due to overloading of the PC's resources.
NOTICE
Software products of PCS 7
Only install PCS 7 software products listed in this documentation on a PC station. This applies
in particular to PC stations used for process mode (OS, SIMATIC BATCH, SIMATIC Route
Control).
Installing and simultaneously activating applications that are not approved by Siemens can
adversely impact the PCS 7 system performance.
The user bears sole responsibility when third-party products are used. If you use third-party
products, these must be installed before you install PCS 7. PCS 7 and these third-party
products should not run at the same time.
Installing PC stations
5.3 Installing the operating system
PCS 7 - PC Configuration (V8.2)
58 Installation Manual, 03/2016, A5E36200050-AB
To Next Page
Loading...
