EasyManua.ls Logo

Siemens PCS 7 - Licensing; PCS 7 Licenses and Quantity Structures

Siemens PCS 7
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Requirement
The DCF77 receiver module has been connected to an available serial port on the PC
station.
Note
Information on the required software and availability of the drivers is available in the
Process
Control System
PCS 7; PCS 7 Readme
file (see "Preface (Page 9)").
Procedure
1. Install the driver.
2. If necessary, use the control panel to change the settings.
Additional information
Documentation
Process Control System PCS 7; Time Synchronization
5.6 Licensing
5.6.1 PCS 7 licenses and quantity structures
Important terms
The following table lists terminology that is important for licensing:
Term Description
License A license provides the right to use products. This right is in the form of:
CoL (Certificate of License)
License key
CoL (Certificate
of License)
The CoL certifies the license. The product may only be used by the license owner
or authorized persons.
License key The license key is the "technical representative" of the license (also called an "elec‐
tronic license stamp").
License properties
Each license consists of a basic license type and a license type.
The basic license type defines how many PC stations the associated software may be installed
and used on. The license type defines any applicable restrictions on how the associated
software may be used.
The following basic license types are available to you:
Installing PC stations
5.6 Licensing
PCS 7 - PC Configuration (V8.2)
98 Installation Manual, 03/2016, A5E36200050-AB

Table of Contents

Other manuals for Siemens PCS 7

Related product manuals