The following connections are available for redundancy communication:
● For OS servers and SIMATIC Route Control:
Null-modem cable to COM interface or network cable (cross-over cable) to an additional
Ethernet network adapter.
● With BATCH servers:
Network cable (cross-over cable) to an additional Ethernet network adapter.
If using a PC as a BATCH server, this is the only type of redundancy connection permitted!
You can find additional information about configuring redundancy in the section " How to
activate redundancy for fault-tolerant PCs (Page 125) ".
Additional information
● You will find information on configuring fault-tolerant components, redundancy and
redundancy monitoring for redundant servers in the manual
Process Control System PCS
7; Fault-tolerant Process Control Systems
.
5.4.7 Installing a PC for Web Option for OS
Installation of PCS 7 Web server and PCS 7 Web client
You can find all the information and step-by-step instructions for installing the following PC
stations in the
Process Control System PCS 7; Web Option for OS
manual:
● PCS 7 Web server
● PCS 7 Web client
● PCS 7 Web diagnostics server
● PCS 7 Web diagnostics client
Additional information
●
Process Control System
PCS 7; PCS 7 Readme
file (see "Preface (Page 9)")
5.4.8 Setting up user groups and users
Some user groups and users are created automatically when PCS 7 software is installed.
The following table shows:
● The software installation on the PC station with which the user groups and users were
created.
● The user group in which a user must be a member in order to use an installed application.
Installing PC stations
5.4 Installing the PCS 7 software
PCS 7 - PC Configuration (V8.2)
82 Installation Manual, 03/2016, A5E36200050-AB
To Next Page
Loading...
