Siemens PCS 7 - Appendix B - Approved Configurations on a PC Station; Approved Configurations

6.2 Appendix B - Approved configurations on a PC station
6.2.1 Approved configurations
Introduction
You can use a PC station for PCS 7 not only in the standard configuration. By installing
additional program packages or taking advantage of special properties, you can use a PC
station for several purposes, for example:
● as an engineering station with BATCH client installation (Configurations with engineering
station, clients and single station system (Page 146) )
● as an OS server and operator station (client installation on server (Page 148))
● as an OS server and BATCH server (server on server (Page 147))
Standard configurations
The following program packages are offered in the PCS 7 system setup when a PC station is
installed:
● Engineering
– For an engineering PC
PCS 7 Engineering, BATCH Engineering, Route Control Engineering, PDM
Appendices
6.2 Appendix B - Approved configurations on a PC station
PCS 7 - PC Configuration (V8.2)
142 Installation Manual, 03/2016, A5E36200050-AB