Display of a chromatograph
The following are displayed for every chromatograph:
Chromatograph name
Physical address (port/slave)
Status
Operating mode (twice with parallel run)
Sample stream name (twice with parallel run)
Duration of run (twice with parallel run)
Actual time bar (twice with parallel run)
Different types of display
The following appearances are possible depending on
the chromatograph status:
Chroma-
tograph
Software Simul-
taneous
Operating
mode
Status
1
Process No Process Device failure
2
Process Yes A: Process
B: Maintenance
A and B ready
3
Process No Process Software < V7.0
4
Laboratory No Manual Ready
5
Process No Process Ready
6
Process Yes A: Maintenance
B: Maintenance
Not started
Selecting a chromatograph
If more than one chromatograph is connected to the
control unit, you can switch between three types of
display using the key :
One chromatograph
Up to six chromatographs
More than six chromatographs.
In display
One chromatograph
Select one of the chromatographs using the cursor keys
.
In display
Six chromatographs
Select one of the six chromatographs using the cursor
keys or
.
In display
All chromatographs
Select the desired chromatograph using the cursor keys
or .
NOTE:
If you subsequently switch to
Six chromatographs
, the control
unit displays six chromatographs starting at the cursor position
of the display
All chromatographs
.
TAB
CURSOR LEFT/RIGHT
CURSOR LEFT/RIGHT
CURSOR UP/DOWN
CURSOR LEFT/RIGHT CURSOR UP/DOWN
Network summary
5GCLAN.CHP, Stand Dezember 22, 1999
5
To Next Page
Loading...
