STARTING THE SOFTWARE
Programs can be started by selecting the corre-
sponding directory and then entering the name of
the program. It is also possible to write batch files
to simplify the procedure. This is described under
The IBM-compatible PC: Files.
Starting
the operating software or GCLAN
Connect the chromatograph to the control computer,
and type following the
DOS
prompt:
C:>
cd \bedi
C:\BEDI
> bedi
The operation cannot be started if
no chromatographs are connected,
all chromatographs are switched off,
there is a fault on the lines.
A message is output in these cases, and the
DOS
prompt
appears again.
Calling the configuration
If you have ordered the additional software package
GCLAN
, start the configuration using the softkey on the
GCLAN
display Measure.
If
GCLAN
is not installed on the control unit: leave the
operating software, and type the following after the
DOS
prompt:
C:\BEDI>
k
or
C:\>
cd \konfig
C:\KONFIG>
konfig
Starting the server software
Connect the server correctly according to the circuit
documents, and type following the
DOS
prompt:
C:>
cd \serv
C:\SERV
> serv .
If you have specified a different directory during the
installation, select this directory instead of \serv.
A useful batch file
The batch file do.bat shown below outputs a comment
menu on the screen and calls an operation or configura-
tion without user intervention. It can be extended e.g.
by a word processing call.
If you enter the command call do as the last line in the
file autoexec.bat, the menu appears automatically when
the computer is switched on. Refer to your
MS-DOS
manual for more details.
@echo off
rem Batch file DO.BAT in directory c:\
cls
if z%1z == zoz goto operation
if z%1z == zcz goto configuration
goto proceed
:operation
cd \bedi
call bedi
rem bedi is also a batch file, therefore CALL!
c:
cd \
goto proceed
:configuration
cd \konfig
konfig
c:
goto proceed
:proceed
@echo off
cls
echo Access chromatograph: Type do o
echo Configure: Type do c
BEDI and Windows
The operating software can be used in a DOS window,
but we cannot guarantee that no problems will be en-
countered. The operating software must only be started
under Windows. We recommend that you boot the con-
trol unit before you call Windows. This ensures that the
resident programs of the operating software are not al-
ready present in the main memory from earlier occa-
sions.
Select the following settings for the DOS window:
Click symbol 386 expanded (main group, system
control) and set Never warn for com1.
Call the PIF editor (main group), open file
DOS_FULL.PIF or DOS_WIN.PIF, select execution
Background.
Click Further options and set both the background
and foreground priorities to 50.
RETURN
RETURN
RETURN
RETURN
RETURN
RETURN
RETURN
Installation of software
16
2SWINSTA.CHP, Stand Dezember 22, 1999
To Next Page
Loading...
