Installation of software
INSTALLATION OF SOFTWARE
Together with the chromatograph you were pro-
vided with four diskettes with 3.5" format:
Operation BEDI V50_1 and BEDI V50_2
Configuration KONF V50_1
Control software PCPU V50_1
Operation and configuration contain software for the
control unit, the control software must be loaded into
the chromatograph.
Generation of backup copies
Produce a copy of all diskettes. The diskettes are not
copy-protected. Use the copies as your working dis-
kettes. Store the original diskettes in a safe place.
First check the file BEDI.BAT
The file
BEDI.BAT
is regenerated when you update the
operating software. If you made changes to the old ver-
sion
BEDI.BAT
, these changes must again be entered in
the new
BEDI.BAT
. An example of this is our storage
program for results RPArchiv.
The commands in
BEDI.BAT
Following installation, the file
BEDI.BAT
appears as fol-
lows:
set clipper=/E:0
lh chromlan z30 a38400
initchro 1 0
if errorlevel 1 goto exit
lh pgcres c: z0 x10 y10 v0
cd c:\bedi
lh lprint c500
call lan (or call switch)
:exit
The meaning of the program names
ChromLAN
Resident program for
communication between
chromatograph and control unit
INITCHRO
Checks how many chromatographs
are connected to the control unit
PGCRES
Resident program, fetches cyclically
from the chromatograph: status,
result and raw data
LPRINT
and
CPRINT
Resident program for printing result,
chromatogram and
BASIC
texts
LAN
Produces the coloured screens for
network summary and operation
SWITCH
Produces the coloured screens for
operation
Latest information on software
It is often the case that changes are
made to the scope of delivery or to
individual program functions after
editing of the manuals has been
completed. Additional information
may therefore be present on the in-
stallation diskettes. Please observe
the message displayed on the screen
at the end of the installation. It is
particularly important
if you have already used an older
software version
or if you require information on
the latest software functions.
Once you have successfully termi-
nated the installation, you should
load the file
README.TXT
using the
MS-DOS
editor and read it carefully.
It is advisable to print this file and to
include it amongst your documenta-
tion.
Installation of software
10
2SWINSTA.CHP, Stand Dezember 22, 1999
To Next Page
Loading...
