Selecting the run
Select the function Reintegration in the selection dis-
play, or press the key in the
display Reintegration. The display File selection ap-
pears.
From the hard disk
Raw data files are stored in the directory of the selected
chromatograph on the hard disk of the control unit if
you have switched on the raw data transmission. Select
using the cursor and confirm using .
Changing the channel
Select Select other channel if you wish to select raw
data files of the other channel.
Load current run from the chromatograph
If you have terminated a run in operating mode Main-
tenance single run and the raw data transmission was
not switched on, you can now subsequently load the
raw data of this run from the chromatograph. You must
do this for both channels if you are working with two
detectors.
NOTE:
The raw data loaded in this manner are stored by the control
unit in the file RC0101A.MAN (for channel A of chromato-
graph 1/1). If you load the raw data of the current run from the
chromatograph several times in succession, this file is re-
peatedly overwritten. This also applies if you do this for sev-
eral runs in succession.
You must store the raw data file if you wish to keep it. This is
described under
Data management (GCARCHIV)
.
Viewing the chromatogram or result
Select one of the keys ,
in the display Reintegration.
The matching result or chromatogram appears without
pressing any further keys. The display Reintegration
appears again when you leave the displays Result or
Chromatogram.
F6: Select run
RETURN
F9: Result
F10: Chromatogr.
Reintegration
5REINTE.CHP, Stand Dezember 22, 1999
19
To Next Page
Loading...
