Optimizing the integration parameters
You can optimize the integration without having to
leave the display Reintegration. All softkey functions
return directly to this display so that the correct integra-
tion parameters can be found very rapidly.
Changing the peak recognition parameters
All parameters of the display Peak recognition can be
modified directly for the selected channel in the display
Reintegration. Details can be found in Register 5, Inte-
gration: Peak recognition and in this supplement under
Peak recognition.
Changing the time program
Press the key in the display
Reintegration, and select the channel. Modify the ap-
propriate parameters in the time events program. The
display Reintegration appears again when you leave the
display Time events program.
Information on the integration parameters in the time
events program can be found in Register 5, Peak recog-
nition and in this supplement under Improved integra-
tion: Three new time events program parameters.
Modifying the components list
Press the key in the display
Reintegration. Modify the matching parameters in the
component list. The display Reintegration appears
again when you leave the Component list.
Reintegration at desk
without chromatograph
If you possess the software packages
PGCSIM
and
GCARCHIV
, you can reintegrate at your desk without a
chromatograph being connected to the PC. This func-
tions as follows:
For example, several analyses are run automatically
at night. The control unit must be connected, and
the raw data transmission function switched on.
The results and raw data are stored on a diskette on
the next morning.
Load the runs from the diskette onto the desk PC.
Optimize the integration (reintegrate) without a
chromatograph being connected. Its function is
handled by the separate software package
PGCSIM
.
Also read the information in this supplement in the
Sections
PGCSIM
and Data management (
GCARCHIV
).
F8: Time events
F7: Components
Reintegration
20
5REINTE.CHP, Stand Dezember 22, 1999
To Next Page
Loading...
