THE DIRECTORIES
ON THE CONTROL UNIT
The software is always installed on the hard disk c:. A
directory structure results with the following subdirec-
tories:
C:
\BEDI \USER
\PLOT
\KONFIG
\PCPU-2 \DRIVER1
\DRIVER2
\DRIVER3
\DRIVER4
\METH \CUMOL
\TEST
\4801
\WACHS
\PGCARCH \GC0101
\GC0102
\GC0103
:
\GC0115
\GC0201
\GC0202
:
\GC0215
BEDI directory
The directory \bedi contains all files required by the
operating software. These included the program files,
inter alia:
CHROM.EXE
Chromatograph display
CHROMLAN.EXE
Communication
INITCHRO.EXE
ChromLAN initialization
LPRINT.EXE
Printer spooler
PGCREINT.EXE
Reintegration
PGCRES.EXE
Multitasking
X.EXE
User interface
Also included, amongst others, are screen drivers, dis-
play texts, info texts, working databases, databases for
describing displays, and index files.
BEDI\USER directory
An item User program appears in the selection display
if a file USER.EXE is present in this directory. You can
start your program USER.EXE from there.
BEDI\PLOT directory
This directory contains files for automatic printing of
chromatographs and results following every analysis.
KONFIG directory
The directory \konfig contains all files required by the
configuration software. The configuration is always ef-
fective on methods present in the directory \meth.
METH directory
The directory \meth contains a subdirectory for each
method, e.g. \meth\cumol. This subdirectory contains all
files belonging to this method. The number of files de-
pends on the complexity of the method. The following
files must always be present:
INSTPGC.DBF
Method contents directory
INSTPU. MEM
Analysis parameters
CFAE.TXT
Configuration of A/D converter
CFG.TXT
Configuration of device type
CFGAO.TXT
Configuration of analog outputs
CFGDO.TXT
Configuration of digital outputs
CFGPRN.TXT
Configuration of printer
CFTEMP.TXT
Config. of temperature controller
TELIA.TXT
Time events program A
Usually present:
KALIA.TXT
Calibration list A
KOLIA.TXT
Component list A
REPORTx.BAS
Basic programs for report
PGCARCH directory
The directory \pgcarch always contains 30 subdirec-
tories \gc0101 ... \gc0215. Report files and raw data
files of the corresponding chromatograph are saved in
the subdirectories, e.g. for the third chromatograph at
the serial interface com1: in subdirectory
\pgcarch\gc0103.
In addition, the directory \pgcarch always contains the files
ALARMREP.STA
Total status of network
GCACTPAR.DAT
Current parameters
GCPAR.INI
Initialization parameters
The number of analyses to be stored per chromatograph
is defined when starting the operating software.
The software
8
2SOFTWAR.CHP, Stand Dezember 22, 1999
To Next Page
Loading...
