EasyManua.ls Logo

Siemens PGC 302 Edition II - CONNECTION OF CONTROL UNIT

Siemens PGC 302 Edition II
248 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Connection of control unit
CONNECTION
OF CONTROL UNIT
The control unit is an
IBM
-compatible personal
computer. It can be permanently connected to the
chromatograph, or it can be transported from
chromatograph to chromatograph and only con-
nected for a short time. In addition, more than one
chromatographs can be operated using one control
unit if they are in a network.
Every chromatograph has four serial interfaces on the
PCPU-2 via which all chromatograph parameters can
be accessed:
SER. 1
SER. 2
SER. 3
SER. 4
TTY or RS232
TTY or RS232
RS485 or RS232
RS485 or RS232
With
PGC 302
SER. 1 is connected as a TTY inter-
face, SER. 3 and SER. 4 are connected as RS485
interfaces to the terminal board for fixed wiring.
With
RGC 202
SER. 2 is connected as a RS232 in-
terface to the front of the chromatograph, SER. 3
and SER. 4 are connected as RS485 interfaces to
the terminal board for fixed wiring.
Local connection of control unit
using prepared RS 232 cable
Connect the plug PCPU to the socket V.2 4 at the front
of the chromatograph (RGC 202) or to the socket
SER.2 at the PCPU respectively (PGC 302). Connect
the other end to the socket com1: of the control unit.
NOTE:
The cable is included in the delivery if you have ordered the
control unit from us together with the chromatograph.
WARNING: Explosion protection
You require permission if you wish to
transport a laptop through the potentially
hazardous atmosphere or if you wish to
open a chromatograph in a division 1 area.
Permanent
local installation of control unit
The pin assignments of the RS232 interface are de-
scribed in your control unit manual. Connect the cable
according to the following diagram:
SER.4 SER.3
TIMEOUT
RESET
PROG.
X 16 Station X 1 RUN
SER.4 SER.3 SER.2 SER.1
Control unit
RS232 / COM1:
9 pin socket
TxD
Signal GND
RxD
2
PGC 302
Interface SER.2
9 pin socket
RGC 202
Socket at front
9 pin socket
GND
3
5
RxD
1
TxD
2
3
Cable:
9 pin D-Sub female <-----> 9 pin D-sub male
Connection of control unit
18
3VERDRAH.CHP, Stand Dezember 22, 1999

Table of Contents

Related product manuals