PCPU-2 directory
The directory \pcpu-2 contains all files required to load
the control software and the interface drivers into the
chromatograph.
INSTALL.EXE
Copies files onto hard disk
LDR.BAT
Installs ChromLAN
LOADER.EXE
Programs the PCPU-2
CHROMLAN.EXE
Communication
INITCHRO.EXE
ChromLAN initialization
PCPU-2L.HEX
Chromatograph control software,
laboratory
PCPU-2P.HEX
Chromatograph control software,
process
The directory \pcpu-2 contains four subdirectories
\driver1 ... \driver4. These subdirectories store all inter-
face drivers for the four serial interfaces of the
PCPU-2
.
UNIDRVx.HEX
TTY/RS232 driver
232CLANx.HEX
RS232 driver
485CLANx.HEX
RS485 driver
THE DIRECTORIES ON THE SERVER
The software is always installed on the hard disk c:. A
directory structure results with the following subdirec-
tories:
SERV directory
The directory \serv contains all files required by the
server software. These include the server software itself
and its parameter files.
SERV.EXE
Server software
SERV.BAT
Start file for the server software
SERVER.CFG
Password, interface parameters
GRAPH.CFG
Recorder ranges for trend
PGC_IN.CFG
Address list of measured
components
SERV\DF32 directory
The directory \serv\df32 contains the board drivers for
the coupling modules.
SERV\DF32\SSnn directories
The directories \serv\df32\ss11 ... ss22 contain the re-
spective interface drivers. The subdirectories ss11 and
ss12 or ss21 and ss22 correspond to the pairs of inter-
faces of the coupling modules (max. 2).
UNIDRV
Modbus driver
COMDRV
D3964R driver
PCBEDI directory
The directory \pcbedi serves as an intermediate mem-
ory for the chromatograph status, printer information
and analytical results.
C:
\SERV
\DF32 \SS11
\SS12
\SS13
\SS14
\PCBEDI
The software
2SOFTWAR.CHP, Stand Dezember 22, 1999
9
To Next Page
Loading...
