Configuration / diagnostics using remote mechanisms
6.3 Configuration using Web Based Management (WBM) and Command Line Interface (CLI)
SCALANCE X-200
172 Operating Instructions, 12/2011, A5E00349864-19
6.3.5.6 The "System Save & Load HTTP" WBM menu
System Save & Load HTTP
The WBM allows you to store configuration information in an external file on your client PC
or to load such data from an external file from the PC to the IE Switch X-200.
You can also load new firmware from a file located on your client PC. You can make the
entries required for this on the page of the System Save & Load HTTP menu.
Figure 6-12 "System Save and Load via HTTP" dialog
Configuration File
Name and possibly also folder path of the configuration file that you want to load on the IE
Switch X-200 or where you want to store the current configuration information.
Note
Whe
n a configuration file is downloaded, the device type is not checked.
Event Log File
By clicking "Save", you can save the event table (event log file) on the local computer.
To Next Page
Loading...
