Configuration / diagnostics using remote mechanisms
6.3 Configuration using Web Based Management (WBM) and Command Line Interface (CLI)
SCALANCE X-200
Operating Instructions, 12/2011, A5E00349864-19
175
Event Log File
By clicking "Save", you can save the event table (event log file) on the local computer.
Firmware File
Name and possibly also folder path of the file (maximum 32 characters) from which you want
to load the new firmware.
NOTICE
If firmware is loaded that is older than the firmware on the device, you will have to reset the
device to the factory defaults after loading the firmware.
If the firmware of an IE Switch X-200 is updated, make sure that the firmware in use is
compatible with the relevant device.
If incompatible firmware is loaded on the device, it will no longer be possible to operate the
device. In this case, compatible firmware will have to be loaded again with the boot loader.
You should therefore remember the following restrictions:
SCALANCE X200-4P IRT, X201-3P IRT and X202-2P IRT are compatible with firmware
X200IRT V2.1 or later.
SCALANCE X202-2P IRT PRO and X204P IRT PRO are compatible with firmware
X200IRT V3.1 or later.
SCALANCE XF204IRT is compatible with firmware X200IRT V4.1 or later.
SCALANCE X201-3P IRT PRO is compatible with firmware X200IRT V4.5 or later.
SCALANCE XF204, XF204-2, XF206-1, XF208 are compatible with firmware X200 V4.1
or later.
SCALANCE X204-2TS is compatible with firmware X200 V4.3 or later.
SSL Private Key File
Name of the file that contains the private key for SSL.
SSL Certificate File
Name of the file that contains the certificate for SSL
Note
The private key and the certificate for SSL are required to allow the user to communicate via
a secure connection with the Web server on the IE Switch X-200.
The files must be available in PEM format.
To Next Page
Loading...
Need help?
General