3 Configuration and commissioning of the Service Bridge
Service Bridge – Setup and Configuration
Entry ID: 109747975, V1.4, 05/2019
Siemens AG 2019 All rights reserved
Addressing with PRONETA
The procedure for addressing with the PRONETA tool (free of charge) is described
in the following section. A requirement for addressing the switch is that it must be
accessible in the network.
Download and manual
"PRONETA Commissioning and Diagnostics Tool for PROFINET"
https://support.industry.siemens.com/cs/ww/en/view/67460624
1. Open PRONETA and click on "Settings".
2. Click on "Network Adapter Selection" (1) and select the network adapter with
which the switch can be accessed (2).
To Next Page
Loading...
