Siemens Industry, Inc. 41 A6V12198161_en--_a
Smart Infrastructure
9.2.1 Adding An NCC
To add an NCC node, complete the following steps (refer to Figure 35):
• Click Add.
• Next, type in the Node number to match the Node number from the Zeus configuration (1-
64).
• Add a Node Name.
• Choose NCC-G as the Node Type.
• Choose the Type of NCC-G Node as either This Unit or Remote Unit.
• Type the TCP/IP Network Address as the IP address of the NCC PC.
• Click Save.
Figure 9–6: Adding An NCC Node
To Next Page
Loading...
