Siemens SENTRON PAC3100 - Parameterizing; Introduction and Operator Interface Parameterization; Groups of Settings

SENTRON PAC3100
Manual, 07/2009, A5E02385159B-01
83
Parameterizing
9
9.1 Introduction
Device settings
The "Parameterizing" chapter describes the device settings. These functions include:
● Adjustment to the physical conditions of use
● Integration into the communication system
● Country-specific settings, ergonomics, device protection
It is possible to set the device by means of:
● The operator interface of the device
● Configuration software
● RS 485 interface
Note
Protection of the device settings
As delivered, the device settings are not protected. At startup, a password should be
assigned and the device protection activated to guard against unauthorized or inadvertent
changes.
9.2 Parameterizing the operator interface
9.2.1 Groups of settings
The device settings are arranged into the following groups. The "SETTINGS" menu shows
the choice of groups:
● Device information
Device-specific numbers and versions.
● Language/Regional
Display language and designation of the phases on the display.
● Basic parameters
Settings for measuring inputs for voltage and current.
● Power demand
Setting of the period duration and synchronization.
● Energy counter
Settings for active energy and reactive energy.