Parameterizing
9.2 Parameterizing the operator interface
SENTRON PAC3100
92 Manual, 07/2009, A5E02385159B-01
Data bits / Parity bits / Stop bits
Range: 8N2, 8E1, 8O1, 8N1
FORMAT
Default
value:
8N2
Response time
Range: 0 to 255 ms
0 = Auto
RESPONSE TIME
Default
value:
0
You can find the function codes for access via the RS 485 interface in the Appendix.
See also
RS 485 interface (Page 26)
Modbus RTU (Page 125)
9.2.9 Display
Device settings for the SENTRON PAC3100 display.
Call: "SETTINGS > DISPLAY"
Figure 9-9 "DISPLAY" device setting
Device settings of the display
CONTRAST Contrast of the LC display.
Range: 0 to 10.
Default value: 5
BACKLIGHT LEVEL Backlighting of the LC display.
ON/OFF switch:
ON / OFF.
OFF: Backlighting switched off
On: Backlighting switched on
Default value:
ON.
Note: Switching the backlighting off increases the service
life of the display. To achieve a service life of more than
10 years, the backlighting should be switched on no more
than 10% of the device operating time.
To Next Page
Loading...
