Parameterizing
9.2 Parameterizing the operator interface
SENTRON PAC3100
Manual, 07/2009, A5E02385159B-01
95
After calling the "EXECUTE" menu entry with F4 , a safety query appears on the
display:
● "ARE YOU SURE YOU WANT TO EXECUTE THE SELECTED FUNCTIONS?"
● "ARE YOU SURE YOU WANT TO EXECUTE THE SELECTED FUNCTIONS?
RESTART REQUIRED"
Answer this query with F1 or F4:
● F1
: Cancels the execution. The display returns to display mode. All selected value
groups are deselected.
● F4
: Yes, execute.
After execution with F4
, the message "SELECTION EXECUTED" appears on the
screen. Confirm the message with F4
.
If the device is reset to the factory settings, the message "SELECTION EXECUTED" does
not appear. Instead, the device immediately restarts.
CLEAR MIN/MAX VALUES Resets all minimum and maximum values to
the instantaneous value.
RESET COUNTERS Resets the energy counters to 0 (zero).
FACTORY DEFAULTS Resets all device settings to the default
values, with the exception of the
communication parameters.
COMMUNICATION PARAM. Resets the entered Modbus RTU
parameters.
EXECUTE Reset function. Resets the selected value
groups.
9.2.11 Password management
Default password
The default password is: 0000
If no user-specific password has been assigned, the default password must be entered when
password protection is switched on.
9.2.11.1 Calling password management
You can find password management in the device settings under
"ADVANCED > PASSWORD"
To Next Page
Loading...
